* Estimated delivery times start from the date of shipment, excluding processing time.
* Actual delivery times may vary due to holidays, weather conditions, or customs delays.
WORST servo step resolution I've EVER SEEN! From end-to-end, they have roughly
8-10 steps, they seem to choke on each (bind) as the stick is traversed across it's range and this
means you will have NO fine control inflight. I was going to use them as
camera gimbal servos but I see now they're NOT accurate enough for the task. Good
for a CHEAP FOAMIE or maybe a boat.
WORST servo step resolution I've EVER SEEN! From end-to-end, they have roughly
8-10 steps, they seem to choke on each (bind) as the stick is traversed across it's range and this
means you will have NO fine control inflight. I was going to use them as
camera gimbal servos but I see now they're NOT accurate enough for the task. Good
for a CHEAP FOAMIE or maybe a boat.
WORST servo step resolution I've EVER SEEN! From end-to-end, they have roughly
8-10 steps, they seem to choke on each (bind) as the stick is traversed across it's range and this
means you will have NO fine control inflight. I was going to use them as
camera gimbal servos but I see now they're NOT accurate enough for the task. Good
for a CHEAP FOAMIE or maybe a boat.
Tips:For questions about your order, place of delivery, product discount, taxation, delivery time, warranty, shipping, payment, exchange rate, and other questions unrelated to the product, please contact customer service.
The Xk line of rc toys usually uses a all in one board. Which has the rx, esc and servo mounted to a single board. The servo plug is usually Jst 1.*****p. The servo you are inquiring about has regular JR,Futaba servo head. No it will not work unless you change the plug end
The Xk line of rc toys usually uses a all in one board. Which has the rx, esc and servo mounted to a single board. The servo plug is usually Jst 1.*****p. The servo you are inquiring about has regular JR,Futaba servo head. No it will not work unless you change the plug end
Answered by Hobbyboy on 06/11/2022Helpful (0)
0
Q:
The picture shows metal gears, but the first tiny gear on the motor itself is plastic. This is the weak/failure point. Do you have plans to make this metal also?
The picture shows metal gears, but the first tiny gear on the motor itself is plastic. This is the weak/failure point. Do you have plans to make this metal also?
I don't think it matters! In a plastic gear servo, the upper gears strip first. I have these servos in a couple of birds and they work well. Try out the Jx line of servo's also.
I don't think it matters! In a plastic gear servo, the upper gears strip first. I have these servos in a couple of birds and they work well. Try out the Jx line of servo's also.
Answered by Hobbyboy on 14/04/2022Helpful (0)
0
Q:
It looks like you need to cut off the old connecters from the old servos and solder them onto the 7350 servos and since they are smaller in size it looks to me that they need to be glued in too (since the screw holes don't line up) Is this correct?
It looks like you need to cut off the old connecters from the old servos and solder them onto the 7350 servos and since they are smaller in size it looks to me that they need to be glued in too (since the screw holes don't line up) Is this correct?
This servo comes with a hitec and Jr style connector if you have another type of connector then yes. You could possibly source a extension adaptor or connector adapter.
This servo comes with a hitec and Jr style connector if you have another type of connector then yes. You could possibly source a extension adaptor or connector adapter.